Multipurpose U Return Pipe U Directional Pipe tube 5/8''~3/4'' Duck Bill Hose

GOOD LITTLE OUTFLOW WORKS GREAT ON MY 75 GALLON

The media could not be loaded. I bought 3 for my Aqueon and Penn Plax filters because the outlets included were poor quality. I bought two sizes because I have two different hose sizes and both fit perfectly. I should add a hose clamp however I do not see the hoses coming off because they are on there really tight. It is really high-quality thick plastic not the cheap stuff that comes with the canister filters. You can tilt the outlets any direction that you want.

The idea, fit, and strength seem fine. As a matter of fact, I would love this if it din't leak. The seam at the hose barb (where you attach your tubing) is misaligned, creating a slow leak. Even when running just a trickle of water through it, the gap that is created by the misaligned plastic is big enough to allow water through. I tried with and without a hose clamp, no difference. Sanding the bump down may be a possibility, however it would mean sanding most of the hose barb down, loosening the fit and effectiveness of the hose barb further. It's hard to see how bad it is in the attached picture, but it shows what I am referencing.Edit: I have been in contact with the seller, and they have been great. It sounds like there was a bad batch or a small number of units that had the issue I described. It sounds like they are taking steps to prevent others from experiencing this issue.

Great option to swap the factory outlet option that comes with the Marineland C360 canister filter and any filter that has the same hose dimensions. Allows a more stronger flow which helps cycle the water in my aquarium and helps with surface agitation to help with gas exchange. I would purchase again!!!!

Plastic is thin, but I don't think that matters as long as you don't put weight on it. I could see it crushing easily without much force. I have used it yet, but the plastic is thin enough I do worry about the seal running down the middle. I wish the arch area was a little smaller. Its wider than it appears in the photo. The suction cup should help with positioning it, but for those with OCD it may rock forward or back a bit if you don't have a wide frame.

This is going to work perfectly for my aquarium. I really likes the suction cup attachment. I had another clip on suction cup this really keeps it right where I put it.

The return tube broke on my Rena Filstar XP1 and I didn't want to spend twice the price on their site. This tube fit perfectly with the original filter tubing.

As advertised