RUS-1000-6C Rust Proofing Clear, 1-gallon

It spay good

Dont get just one gallon for your car, buy two for a NEW car with 4 doors. I thinned it down some and used my own homemade hose-spray head. Used some 3/8"ID vinyl tube that I heated end and melted it flat-closed then nail heated to poke small holes into it at different angles like a "5 on a dice pattern" on both sides with some poked into the flattened ends too. fine mists and directional into the corners of frame,buy some tyvek jump suits with head coverings and cheap latex gloves and plastic sheeting to cover over the car. tape up the seams from hood & fenders and pull inner fender liners and bumpers to do it right also pull door panels.

Past experience with this product proved positive results.

The Rust Proofing was too thick to go through the gun. I had to thin it with Kerosene 30%.

Been using for over 20 years for corrosion fighting

This stuff is thick and covers well , I thinned some with mineral spirits and blew it into hard to reach areas giving it a fog affectI would buy this again and again to protect my trucks from rust if I had some kroil I would mix it and allowing it to creep into the smallest cracks

Great stuff. Did two trucks. Will order more in the Spring to finish the others

Easy to use and good and thick so that it covers well