MolexMicro-Fit 3.0™ Dual Row (14 Circuits) Male & Female Receptacle Plug, w/Terminal sockets, (Pack of 1 Complete Set)

I purchased this to create a disconnect for the hotend on my ender 3 3d printer. This worked very well, and they give you one extra crimp for either end which is helpful. Definitely saved me!

Worked great! Make sure to buy a crimping tool too to make it look like a factory connection. I used this to repair a signal cable for some Bennett trim tabs. Saved a couple hours (trying to pull a new one) plus the $100 cable

They are very small connections

Purchased this connector but needed 12 pin DIP; ordered this one by mistake.