Oshlun SBW-055018 5-1/2-Inch 18 Tooth ATB Fast Cutting and Trimming Saw Blade with 5/8-Inch Arbor (1/2-Inch and 10mm Bushings)

I purchased the 24 and 36 tooth versions of this blade and found them both to be excellent.I have used these blades many times in the past and they have worked very well in cutting 1 x and 2 x wood stock. They cut with a clean edge and are very stable in my saws.Note-----These blades in the 51/2 inch size have a 5/8 inch arbor hole!!! If your saw has a 1/2 inch or other sized blade shaft you will need to buy some blade arbor adaptors (don't worry they are easy to get and not very expensive. Amazon has these too.)The pricing on these 51/2 inch blades is reasonable and the blades are of very good quality.

Excellent blade! Yes it’s a little pricier than some blades but this is an excellent finishing blade and well made.Also, if you’re experiencing shredding or burning as some reviewers have stated, then double check your rotation. I’m using this on an old 18v Ryobi. It’s left hand drive...the blade spins in a clockwise direction! Label goes in towards the saw, not out facing you if you have this saw or one similar. Also be sure to use the proper arbor insert.I’m using this on poplar and oak slats up to 1x3’s and this blade has been an extremely sharp and smooth cutting blade.

I've now used this blade for about 40 cuts or more. It's done well, but I do feel that it's slowing down some.I would buy it again should I chose not to pay up for one of the top of the line blades. It is a lot better than the last 5.5" blade that I purchased. That one was bad in about 5 cuts.

using it on birch plywood cuts smooth with no splinters. good and sharp just out of package.good cost effective brand. would buy again.

Couldn't find any finishing blades or my 5.5" circular saw at my local hardware stores and ran across these on Amazon. The price was great so I figured I would just go ahead and order two.They fit great on Ryobi circular saw and allow for good cuts the only problem is that you have to be careful what type of wood you use it on or it could burn the wood as you cut it. Aside from that it has with sound a lot of uses and still works fantastic. I haven't cleaned it yet and used it maybe a dozen times and there is no rust forming on the blade.

Using it on a Ryobi One+ circular saw. It does a nice job of cutting compared to my prior 24-tooth saw. Less tear out and no wood burns since I switched blades. A bit more tear out on the crosscuts, but it's not consistently an issue. Been using it mostly with walnut, red heart, maple. Also did well with plywood sheets.

Worked perfectly on particle board, cutting smooth, no jagged edges or grabbing. Leaves a very smooth edge.

Oshlun 5-1/2-Inch 36 Tooth Blade 5/8-Inch Arbor 1/2-Inch and 10mm Bushings. Used on favorite old Craftsman 5-1/2 trim saw. This blade seems to be well made, should work as a replacement due to 1/2" arbors blades are no longer available. The package states "Arbor 5/8" with 1/2-Inch and 10mm Bushings". The adaptor arbor bushings were not included in the blade package. After receiving this blade, I ordered one 5/8" x 1/2" bushing adaptor from Amazon at $8.37 additional not realizing it should be included. This additional expense for the bushing is why I'm not giving 5 stars. The bushing seem to work.

The blade was very easy to install onto my Ryobi 5 1/2" circular saw using the provided adapter to fit the 3/8" bushing on the saw. The printed side of the blade faces inward towards the motor, the plain side faces outwards. I've only made one test cut so far, on a 2"x.5" piece of mdf casing. I remembered to turn the good side down as recommended for the best cut. I'm very very pleased with the quality of the cut--it's better than the factory cut. I can't speak yet to the longevity of the blade. Will update at a later date.

Muy eficiente y de buena calidad

Corta muy bien, es una sierra circular excelente. compré 3 de esta marca con distintos dientes y esta es la que más ocupo por la calidad del corte (depende del corte que se ocupe) que necesito, me ha durado bastante y creo que me durará aún más tiempo. Es muy recomendable, de mucha, mucha calidad.

Excelente compra

Se ve resistente